![background image](https://i.inkjetdoc.com/HP Deskjet 6988 Printer/en/HP Deskjet 6988 Printer_en042.png)
Embedded Web server (EWS)
The embedded Web server (EWS) provides a simple way to manage the printer on a
network.
Use the printer's EWS to do the following:
●
Check the printer's status.
●
Adjust the printer's network configuration.
●
Check estimated ink levels in the print
cartridges.
●
View network statistics.
●
Configure the printer's
wireless security
settings
.
●
Configure
Bluetooth settings
●
Visit HP's Web site for support
information and to purchase supplies.
Caution
It is recommended that the printer and the computers that use it be on
the same
subnet
. Printer installation across subnets can be problematic
depending on the type of router used.
Before using the printer's internal Web page, verify that the printer and the computer are
powered on and connected to the network.
Chapter 4
(continued)
40
HP Deskjet 6980 series
![background image](https://i.inkjetdoc.com/HP Deskjet 6988 Printer/en/HP Deskjet 6988 Printer_en043.png)
Open the Embedded Web Server
Follow these steps to open the printer's internal Web page:
1.
Launch the Internet browser.
Use Microsoft Internet Explorer 5.0 or higher or Netscape 4.75 or higher.
2.
Enter either the printer's
IP address
or
host name
in the browser's address box.
Note
If the printer is on a different
subnet
than the computer, enter the
printer's IP address (for example: http://192.168.1.1) in the browser's
address box to open the embedded Web server. Also, if the computer uses
a proxy server to access the Internet, you might need to configure the
browser to by-pass the proxy server in order to access the EWS.
If you do not know the printer IP address or host name,
print an HP Report page
.
Caution
Use caution when changing the print server's wireless network
settings; you can lose the connection. If you lose the connection, you might need
to use the new settings to reconnect. If the printer loses its network connection,
you might need to reset it to factory defaults and reinstall the software.